Rapid Recovery Complex with advanced protection for superior wear and post-procedure recovery.
Until now, the post-procedure market was seriously lacking
in immediate post-procedure products that offer positive user experiences to
patients. The primary products patients used during recovery were Vaseline or
Aquaphor (petrolatum), leaving your skin hot, red, sticky and shiny for
multiple days post-treatment.
Marini BioShield is the first product of its kind. It is a
silicon-based, non-petrolatum product for advanced post-procedure barrier
protection and repair. This patent-pending formulation combines targeted growth
factors and peptides with hyaluronic acid and CoEnzyme Q10 to reduce downtime
and enhance treatment results. BioShield's near-invisible matte finish protects
the skin, speeds recovery and significantly increases user satisfaction by
minimizing or eliminating the objections and social impact common to
Available in a 2 oz. tube.
This product is intended to be applied like a mask in a
thicker layer to cover the skin for barrier protection. It is not meant to be
rubbed in or patted on. For best results, apply as follows:
Always wash hands prior to application.
Apply a uniform, slightly visible layer over the entire
Apply product in one direction only
using slow, smooth, and long motions.
For most uniform coverage, apply
the product using multiple pea- to dime-sized increments as required.
Starting along the tear duct,
spread the product directly across the face toward the outer edge of the cheek
Repeat motion in stripes from the
center face to the outer jawline progressing downward across the cheek to cover
the entire mid-face and upper lip.
Starting at the center of the
forehead, spread toward the temple and down the outside edge of the face.
Repeat to cover the entire forehead.
To cover the chin, start along the
outer jawline, near the ear, and spread toward the center of the chin.
Repeat for the opposite side of the
The product will slowly dry, creating a flexible, enriched
silicone barrier on the skin for recovery.
Do not 'spot fix' once applied.
To fix areas after application,
thoroughly remove all product and reapply.
After recovery, the product may be used in a thin invisible
layer to enhance hydration and provide continued recovery benefit. Make-up may
be applied over the product at this time.
Recommended for all skin types.
Cyclopentasiloxane, Dimethicone Crosspolymer, Dimethicone,
Water/Aqua/Eau, C12-15 Alkyl Benzoate, Glycerin, Polysorbate 20, Palmitoyl
Tetrapeptide-7, Palmitoyl Oligopeptide, sh-Oligopeptide-1, Ubiquinone,
sh-Polypeptide-22, Bisabolol, sh-Polypeptide-1, Tocopherol, Sodium Hyaluronate,
Carbomer, Butylene Glycol
Features & Benefits:
Built with Volusion